Home > UTV > X3 Turbo 120HP >

CanAm X3 Turbo 120HP Intercooler Upgrade Kit
pwrtune-X3-120IC


 
Alternative Views:


Our Price: $824.99

Stock Status:(Out of Stock)


Availability:: Usually Ships in 24 Hours

Intercooler Fan Control

X3 Intercooler Fan Override Switch and Harness Kit [Add $65.00]
Blow Off Valve or Plug

add Turbosmart BOV with Outerwears Cover [Add $179.55]
add Turbosmart BOV [Add $164.55]
add Plug for BOV Port [Add $11.95]

Qty:  
Description
 

CanAm X3 120HP Turbo Intercooler Kit

2018-2021 all X3 120HP models (including Max, XRC, XMR)

  • 2018-2021 Turbo R Intercooler with Fan
  • High Pressure Silicon Hose
  • 1.0 inch port for Blow Off Valve
  • Black Silicon Charge Tubes (grey out of stock)
  • Easy 20 minute install
  • Hoses Molded to Fit Like Stock
  • Will add 50+HP with the correct ECU tune

Use this kit to add a Turbo R X3 intercooler to your 120HP model X3. This kit includes the hoses and intercooler, but is not recommended to run without an ECU reflash. Check out our pwrTune ECU Reflash's or the Power Vision CX for a great tune safe for use with this intercooler kit. The intercooler is the same used on all 2018 Turbo R 172HP X3 models and is a direct drop in for your car.

Note: Your ECU will not operate your Intercooler Fan even though the wiring is there. You will need to add one of our optional Intercooler fan On/Off switches to turn your fan on if you are running a 120HP spec ECU tune. Or, if you are upgrading to a 2018 Turbo R spec tune the ECU will control the fan. It is not recommended to run the intercooler without the fan on in any full throttle conditions.

The great looking black silicon charge tubes will help dress up your X3 with added performance features. Unlike the stock rubber hoses these silicon hoses are less likely to slip loose once installed correctly. The 1.0 inch port can be purchased with the optional plug, if you do not want to use a Blow Off Valve. You can also choose either our Black Aluminum or Turbosmart Blow off Valves (note when purchasing with a Blow Off Valve all hardware will be included to make a complete Blow Off Valve kit). We also have an optional T-Bolt clamp kit for added protection.

This complete kit takes maybe 30 minutes to install. All you have to do is swap your charge tubes for the new silicon units, plug in the new boost/vacuum nipple, and attach your new blow off valve. The kit locates your new valve behind the drivers compartment access panel so it's shielded from flying rocks and right behind you for the best sound. We configure and test these valves at our shop so they are ready to run. No adjustment is necessary for the best performance.

When properly installed the charge tubes are rated to hold 30+ psi boost pressure.

This Kit Features

2018-2020 Turbo R Intercooler and Fan
Primary and Secondary Charge Tubes
Optional Plug for BOV port
When Purchased with a Blow Off Valve:
  • Manifold Port for Vacuum/Boost Reference
  • Boost/Vacuum Hose
  • Install Instructions


Share your knowledge of this product. Be the first to write a review »